For users needing more modern features or official support, consider exploring Carveco , which was founded by the original ArtCAM development team to continue the software's legacy. ArtCAM and Toolpaths
| Issue | Likely Cause | Solution | |--------|---------------|----------| | Setup hangs on “Registering components” | Antivirus / UAC | Disable AV, run as Admin, use clean boot | | “HASP not found” after update | Driver mismatch | Reinstall HASP driver from \Support\HASP\ | | Crash on 3D view rotate | OpenGL compatibility | Enable legacy OpenGL mode: edit artcam.ini → OpenGLVersion=1.1 | | Cannot save toolpaths | Missing write permissions | Run ArtCAM as Admin, set folder full control | | Update says “ArtCAM not installed” | Registry key missing | Reinstall base, do not rename installation folder | artcam pro 91 installation upd
During the setup, when prompted to install the dongle driver, select initially. For users needing more modern features or official
