Bosch M7 Ecu Pinout

| Pin | Sensor | Signal Type | Notes | |-----|--------------------------|----------------------|-----------------------------| | 32 | Crankshaft position (CKP)| Variable reluctance | 58‑2 or 60‑2 tooth wheel | | 44 | Camshaft position (CMP) | Hall effect | Synchronization | | 17 | Manifold absolute pressure (MAP) | 0–5V analog | Optional – some use MAF only | | 12 | Mass air flow (MAF) | 0–5V or frequency | Hot-film | | 11 | Intake air temp (IAT) | NTC thermistor | 2.5kΩ @ 20°C | | 13 | Engine coolant temp (ECT)| NTC thermistor | 2.5kΩ @ 20°C | | 29 | Throttle position (TPS) | 0–5V dual track | Redundant for E-gas | | 21 | Oxygen sensor 1 (pre‑cat)| 0–1V (narrowband) | Titania or zirconia | | 22 | Oxygen sensor 2 (post‑cat)| 0–1V | Catalyst monitor | | 8 | Knock sensor 1 | Piezoelectric | Shielded cable | | 9 | Knock sensor 2 | Piezoelectric | Shielded cable | | 51 | Vehicle speed (VSS) | Square wave (0–12V) | From ABS or transmission |

The M7 series ECUs are digital control units that analyze data from various sensors to operate injectors and ignition coils. Bosch M7 Ecu Pinout

On the ECU casing, pins are numbered sequentially from per connector. Pin 1 is usually indicated by a small triangle or indentation. | Pin | Sensor | Signal Type |