Fanuc Wn57 Override Function Is Active ((better)) Site

: This message often triggers when the machine is in a "Setup" or "Maintenance" mode where standard safety interlocks (like door switches) are bypassed, or when the feedrate is locked to a specific percentage (e.g., 100%) to ensure predictable behavior during automated cycles. Common Causes & Solutions

The "WN57 Override Function is Active" message on a Fanuc CNC typically refers to a specific condition within the ladder logic . This message is generally not an error code from the Fanuc system itself, but a custom operator message or warning defined by the Machine Tool Builder (MTB). Core Meaning fanuc wn57 override function is active

If you see this message and need to clear it, check the following: : This message often triggers when the machine

?

: Since "WN57" is builder-defined, your machine’s specific manual (e.g., Doosan, Mori Seiki, Haas) is the primary source for this specific code. Core Meaning If you see this message and

: It indicates that an override setting—such as Feedrate Override, Spindle Override, or Rapid Traverse Override—is currently engaged or forced.

: In many Fanuc PMC (Programmable Machine Control) ladder designs, WN57 (or similar window markers) signals that a forced I/O or override mode is engaged. This can be used to prevent the machine from starting a cycle if the override is set too low (stalling the tool) or too high for a specific setup.