Hx711 Proteus Library Link Info

To use the HX711 library in Proteus, follow these general steps:

Use the standard HX711 library (by bogde) in Arduino IDE, but modify it slightly for Proteus timing if needed. hx711 proteus library

When setting up your simulation, follow this standard wiring for or 8051 microcontrollers: 📍 Pin Mapping VCC: Connect to 5V DC. GND: Connect to Ground. DT (Data): Connect to any Digital Pin (e.g., Arduino D3). SCK (Clock): Connect to any Digital Pin (e.g., Arduino D2). To use the HX711 library in Proteus, follow