Here is the text for a . This is a generic, technically accurate representation based on standard marine VHF antenna installation practices and Simrad's typical documentation style.
Despite careful installation, issues may arise with the RF300 system. Consult the troubleshooting guide in the Simrad RF300 installation manual for common problems and solutions.
: It outputs a variable frequency signal centered at 3400 Hz , with a change of 20 Hz per degree of rudder movement.
: Variable frequency signal (square wave) read directly by Simrad/Robertson autopilot computers. Simrad Commercial Setup & Calibration
: (hypothetical – refer to product label) IC : (hypothetical – refer to product label)
The RF300 uses a two-wire connection to transmit a digital signal to the autopilot computer. Simrad Commercial